Electrifying my Roman saber

thehousejedi (Carl Grasso) · Posted: Sun Jul 31, 2016 8:55 pm Post subject: Electrifying my Roman saber

So I recently received my OWK ROTS saber from Roman Props. The inner diameter of the saber is much smaller than the standard MHS style parts so I'm a bit out of my depth when doing the electronics side. Too much of it is likely going to be custom. Plus I'd like to use a crystal focus card and my soldering skills may not be up to the challenge. I'm wondering if anyone out there knows of trust worthy people that will take an empty hilt and do the electronics? Ideally within a few weeks.
_________________
Rebel Legion, Alderaan Base: ROTS Obi-Wan Kenobi
501st Legion (IC/ID/IG/TI - 18420), New England Garrison - Green Mountain Squad: Imperial Bridge Crew, Tie-Pilot Reserve, Imperial Gunner, Imperial Security Bureau officer, Rogue One

rlobrecht () · Joined: 05 Jan 2016 Posts: 64 Medals: None

You might try the forums over at fx-sabers.

thehousejedi (Carl Grasso) · Posted: Mon Aug 01, 2016 10:16 pm Post subject:

yeah. i always forget about them. the forums always seem very old there, nothing new going on.
_________________
Rebel Legion, Alderaan Base: ROTS Obi-Wan Kenobi
501st Legion (IC/ID/IG/TI - 18420), New England Garrison - Green Mountain Squad: Imperial Bridge Crew, Tie-Pilot Reserve, Imperial Gunner, Imperial Security Bureau officer, Rogue One

DougD () · Posted: Mon Aug 22, 2016 3:01 am Post subject:

Look up Sabergasm on Facebook. 4-5 smiths across the US that have banded together and are doing installs.

I used a guy I know named Shameem for mine. Unfortunately cannot recommend. For $350 the parts were just shoved in the hilt with electricians tape and a plastic rube. No chassis used in the install. I wasn't happy.

thehousejedi (Carl Grasso) · Posted: Mon Aug 22, 2016 3:49 am Post subject:

Thank you! I just sent them a message.
_________________
Rebel Legion, Alderaan Base: ROTS Obi-Wan Kenobi
501st Legion (IC/ID/IG/TI - 18420), New England Garrison - Green Mountain Squad: Imperial Bridge Crew, Tie-Pilot Reserve, Imperial Gunner, Imperial Security Bureau officer, Rogue One

jedi_keith () · Posted: Fri Oct 07, 2016 1:26 am Post subject:

You ever get this finished? I just finished installing electronics in my inception.

Forum and Costume Controls