View previous topic :: View next topic |
Author |
Message |
Retrofire (Peter)
Joined: 27 Jan 2018 Posts: 44 Location: Arizona Medals: None
|
Posted: Sun Nov 25, 2018 7:09 pm Post subject: Help with trimming a RFT helmet swoop
|
|
|
I recently got a RFT helmet and I need some help in cutting out the rear swoop. Are there any patterns available to use or does anyone have a good method for trimming one out? Thank you very much for your help! _________________ Peter Holzemer
TB-91005 Scout Biker
“Retrofire”
RAID Recruit - Endor Commando |
|
Back to top |
|
 |
DroidWelder () Active Legion Member

Joined: 21 Aug 2008 Posts: 997 Location: Arizona Medals: 2 (View more...)
|
|
Back to top |
|
 |
kman () Active Legion Member
Joined: 25 May 2016 Posts: 1349 Location: Tarzana, CA Medals: 1 (View more...)
|
Posted: Wed Apr 17, 2019 1:32 am Post subject:
|
|
|
Hey, David, any chance I can get an assist with this? I was planning to just copy the pre-built helmet I have, but if you have some tips... _________________
 |
|
Back to top |
|
 |
Retrofire (Peter)
Joined: 27 Jan 2018 Posts: 44 Location: Arizona Medals: None
|
Posted: Wed Apr 17, 2019 2:16 pm Post subject:
|
|
|
kman wrote: | Hey, David, any chance I can get an assist with this? I was planning to just copy the pre-built helmet I have, but if you have some tips... |
It would be great if someone could work up a basic swoop pattern and pin it to the RFT thread. That’s a tricky part of the build and if you mess it up you got to start over which can be rather expensive.  _________________ Peter Holzemer
TB-91005 Scout Biker
“Retrofire”
RAID Recruit - Endor Commando |
|
Back to top |
|
 |
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot post calendar events in this forum
|
|