Forum and Costume Controls
REMINDER: Do not change your e-mail address yourself. Please read this first
|Viewing costume :: Rey (Rise of Skywalker)
Rey (Rise of Skywalker)
Active Legion Member
||Rey (Rise of Skywalker)
|Blue and/or yellow
Three bubble braid ponytail style. I
used bun makers
cut in half to create more volume in
(side note my bottom hair bubble
was falling out, normally this doesn't
happen, figures it happens during
Top is made from a cream jersey
knit. It is lined and has raw bottom
It has raglan sleeve stitching, cap
sleeves and a curved standing
Whip-stitching was applied to neck
edge, collar, raglan sleeve seam,
edge and side seams.
The hood is made from sable suede
in a cream shade. The lining is a
crepe in cream.
The hood has a center seam in the
back but does not continue to the
top of the hood.
It has two darts just behind the
Pants are made of a pure white
Ultrasuede fabric and lined with a
soft white knit for modesty.
Pants have a side split at the bottom
There is a center leg seam up the
front and back of pants. Double
stitched on both sides
of the seam.
The knee pad has a layer of batting
and stitched with 5 ridges, the
middle being the largest ridge.
There is an invisible zipper in the
I've made 3 different styles of wrap
dresses. One of light chiffon, power
mesh and silk tulle.
All are in an off white shade.
The power mesh and silk tulle are
the full width of fabric gathered,
where the chiffon one is
only half the width (approx 30
The dress crosses in the back and
the front. One side is looped and the
other side is free fall.
I have three obi's to match the
correct wrap dress.
Wraps are made of pigskin garment
leather in a light beige. There is a
seam up the back of the
first four wraps and the bottom half
wraps around and tucks into itself.
Upper Arm wrap:
Made of 4 oz hide leather and dyed
with saddle tan.
Wrap starts 3 inches wide and
narrows to 1 inch wide after
wrapping 3 times around.
4 oz leather in saddle tan.
4 oz leather in saddle tan. Upper
belt is just shy of 2 inches wide with
2 silver rectangle closures.
Back of the belt has a stay to keep
the access strap in place.
Lower belt is just more than 1 inch
wide. Rectangles are set back
behind the holster strap.
The belt buckle is made of thermal
plastic and painted to appear as
Side has 2 slits for the lightsaber to
be held in.
Natural hemp cord is wound around
the belt 12 times as seen in the film.
4 oz leather in saddle tan. Made
exactly like the previous Rey holster
only I added 2 rivets in to hold
the structure together in the front as
well as 2 in the body.
The leg strap has 2 rectangles to
weave the strap through as well as
an "X" stitched into the side. The
strap wraps around and hooks onto
a browne stud (this is how it's closed
in the film)
Po Zu linen boots
3D print of the blaster (already
approved from previous Rey
I have a repaired graflex hilt prop