Rey (The Rise of Skywalker)
jeniwan (Jenna Hunt)
Legion Costume Judge
Great Lakes Base
||Rey (The Rise of Skywalker)
All pieces are made by my husband
(LB-47) unless otherwise noted:
Cream cotton jersey V neck, lined with
a lighter weight knit. All seams are
trimmed with blanket stitching. The
attached hood is made of suede
neoprene, with a crepe lining. The
lining has a boxed pleat in the center.
Soft white silk with a subtle horizontal
weave, used at full bolt width (54")
wide and wet pleated.
Made from the same silk as the
tabards, with a hidden closure in the
Bright white twill, modified from
existing pants to add knee pads and
the vertical seams down the front and
back of the legs. (Back seams were
added after most of these photos were
taken; please see detail.)
A thin, taupe goat(?) skin. The seam
goes halfway up the wrap and the
loose ends wrap around the wrist and
close with hidden velcro.
Belt, Holster, Bicep Cuff, and Wrist
These leather pieces were made by
Kristen Jones (J and K Props) and were
made to match the details seen in
TROS. The belt has the new buckle and
slit for the lightsaber, the holster is
devoid of decorative stitching, and the
wrist bracer wraps differently from
Po-zu Rey boots in Natural Linen.
My own hair is done in the new
"bubble" style, with mesh inserts
added for volume.
Hilt is 3D printed and finished by me.
This is the "repaired" version seen in
TROS, with a leather cuff wrapped
around the new clamp.
The bladed version is a TFA-style
Korbanth graflex assembled by my
husband (and soon to be upgraded :) )
Blaster is 3D printed by Traywick
Designs and finished by me. This prop
was previously approved with my
Resistance Rey costume.
For reference album, see here:
For standard mock-up, see here:
(I co-authored this document with Alex